10/18/2023 Map Stopped Working?
Visit this post for the fix
I have 2 maps going now and they are not even close to showing the same METARS. Even the map layout feature only shows a few IFR spots, but the map is full of RED. All the airport codes are correct. I did have a GND wire going to power +5v so I wonder if I damage the PI?
The LED light colors are correct in the layout settings
The map on the left in the pic is what I believe to be correct. You can see all the airports in red on the right.
Ron, double check that the "RGB or GRB LEDs Used" under "LiveSectional Settings" setting is set correctly for the type of LED's you are using. Based on your picture I believe the one on the right is not set correctly. Double check it. The description states;
Depending on LED model used colors may need to be in RGB (i.e. WS2812 strip) order or GRB (i.e. WS2811 strand). NOTE: If LED Colors seem wrong (typically Red), switch this setting and retry.
Let us know. - Mark
You are a genius Mark, that did it! It's odd as I had it working earlier and the colors were correct. Whew!
No problem. Genius might be a bit of an exaggeration, but I appreciate the kudos! - Mark
Well you know this stuff inside and out, so that makes you a genius.
