Forum

That was it. Thanks. I am also getting a brightness flicker every 10-15 seconds or so. I've been experimenting with the brightness setting of...

I have the exact wires you linked above. I’ve tried three different ones and they all require holding the connection firmly to keep the map working p...

I put together a new board with a new converter and all soldered connections. Seems like I have it mostly working correctly now. Only issue I am hav...

I ordered all of my stuff from the links here however the power supply linked is no longer available. It has specs of 5V 10A 50W. The one I went wit...

How would I go about powering the other end of my LED string? Where should I pull the power from?

The semi-circle is on the left. LEDSs signal is being fed correctly according to the arrows. Power supply is 5V 8A 40W. I disconnected the second st...

I just have the led light strings plugged together. There are also bare ends at beginning and end of each string for power and ground. Do I need to ...

Here are some photos.

I'm now getting essentially zero response from the LEDs. I moved things on the board multiple times, replaced jumpers all with no result. The map is...

So I moved a few things to different pins on breadboard. Wired as the diagram. Was working better but got an occasional flash. I rebooted and now i...

In progress project photo.

Ok will go back and check. The frustrating part is it worked perfectly when half done.

Took it all apart and rewired the circuits. Think my problem was I didn't realize that the ground and power wires had to be in a specific order on th...