Last seen: Nov 21, 2024
My guess is that you will find that its a wiring issue. Be sure the power supply for the RPI and the power supply for the LED's are both grounded toge...
That's an awesome map! Great job. As a quick workaround, if you go into the config editor and go to the led colors section. Find the No Weather Repo...
That's interesting. V2 handled changing the LED colors very differently than V3, where all LED's are controlled all at once. So my thought is that t...
Anytime I've had phantom LED behavior it came down to 1 of a few things. As already mentioned, if the RPI is not grounded to the same ground used ...
If the LED's aren't being lit by the RPI directly and you are using the Power USB to power the board up, then the only thing I can think of, is the po...
Captain Ron, The situation you are describing is almost always caused because another process is running that is controlling the board. So when you ...
Captain Ron, Here's the output from the FAA for K088 using this query; So the FAA is not providing any data for this location. - Mark <re...
Captain Ron, Were you able to get your IP address? After wifi setup via raspi-config, upon reboot the software should provide the IP address on a mo...
Hi Captain, I 3D printed a bezel, that also mounted the 5 OLED's I was using. Then soldered the OLED's with wires, without using a circuit board. I ...